Quote from
Mario on May 13, 2019, 9:45 am
Hello JYoung,
For some reason it looks like your antsle did not find the antlets zpool which the 'zpool import -a' command probably resolved as well as the error message about "cannot find init path..." when trying to start the antlet.
Regarding the degraded hdd zpool, each zpool is a pair of mirrored drives. The 'resilvering' message is zfs's way of saying it is re-syncing the mirror. You can also run
zpool scrub hdd
which will verify/correct the data on the drives.
If the degraded status persists it may be a bad drive and we would gladly repair that for you. You can contact us via the 'Support' link in anthill.antsle.com
You might want to test by creating a few antlets on the hdd zpool to see if the zpool goes into a 'degraded' state again.
Hello JYoung,
For some reason it looks like your antsle did not find the antlets zpool which the 'zpool import -a' command probably resolved as well as the error message about "cannot find init path..." when trying to start the antlet.
Regarding the degraded hdd zpool, each zpool is a pair of mirrored drives. The 'resilvering' message is zfs's way of saying it is re-syncing the mirror. You can also run
zpool scrub hdd
which will verify/correct the data on the drives.
If the degraded status persists it may be a bad drive and we would gladly repair that for you. You can contact us via the 'Support' link in anthill.antsle.com
You might want to test by creating a few antlets on the hdd zpool to see if the zpool goes into a 'degraded' state again.