Antsle Forum

Welcome to our Antsle community! This forum is to connect all Antsle users to post experiences, make user-generated content available for the entire community and more. 

Please note: This forum is about discussing one specific issue at a time. No generalizations. No judgments. Please check the Forum Rules before posting. If you have specific questions about your Antsle and expect a response from our team directly, please continue to use the appropriate channels (email: [email protected]) so every inquiry is tracked. 

Please or Register to create posts and topics.

LEMP-LXC on nano/pi

I have set up the Lemp-LXC on my antsle nano as well as on my own pi and found that on either device that my Lemp stack seems to stop responding and requires a reboot after roughly an hour or 2 (not sure exactly how long) I am not sure if that is to be expected on these little guys or not, or how to check what is exactly going on. also what is the expected behavior of Autostart? I was assuming the if the unit reboots that it would autostart the antlet however it seems to be non functional on either of my devices. Thanks in advance.

Hi warren:

Thanks for letting us know about this potential bug in LEMP Stack-LXC for nano.

We will do some testing on our side to see what is happening.

Thanks.

@daniel-luck Has there been any updates to this issue with your testing?  I am having the same issue with a LEMP-Stack-LXC that I just created last night.

Hi @spyeagle

We have confirmed an issue with the LEMP-Stack LXC for the nano for those used bridged networking and Static IP Addresses.

Were you using a Static IP Address on your Bridged NIC?

I am seeing LEMP-Stack LXC on an Antsle One XD Pro.   This is also using port forwarding and not a static IP or bridge NIC.   Is there an update on how to debug and find out why it simply stops responding.