Antsle Forum
Welcome to our Antsle community! This forum is to connect all Antsle users to post experiences, make user-generated content available for the entire community and more.
Please note: This forum is about discussing one specific issue at a time. No generalizations. No judgments. Please check the Forum Rules before posting. If you have specific questions about your Antsle and expect a response from our team directly, please continue to use the appropriate channels (email: [email protected]) so every inquiry is tracked.
Can no longer access (and a clicking sound)
So this afternoon I started hearing this clicking noise, originally sounded like there was a cricket in the house. When I realized it was my Antsle, I tried to connect to AntMan and couldn't. Attached monitor shows nothing, that is, it is blank.
I disconnected the power and waited a while, plugging it back in did not change anything.
It is about 6 years old, it has both an SSD and HDD.
Any advice on what I can do to get her up and running again?
Hi @madpink
The "clicking sound" could indicate a bad / defective hard drive (HDD).
However, our standard configuration for antsle's has two mirrored HDD's and two mirrored SSD's. So it's possible that only one drive (HDD) is bad and making the clicking sound.
You can try performing fresh install (or factory reset) that will bring your antsle to latest edgeLinux and antMan:
https://docs.antsle.com/get-started/getting-started-with-edgelinux-software-only-version